PC Polycarbonate in Vertical Injection Molding

PC, or polycarbonate, is an engineering thermoplastic used in products where appearance, dimensional stability, impact behavior, or electrical requirements may matter. For vertical injection molding, PC may be discussed for insert molded parts, housings, covers, and electrical components.

The general material name is not enough for machine selection. The exact grade, drying requirement, part geometry, mold design, and insert layout should be reviewed before configuration discussion.

The image above is an illustrative material concept, not a Deboge machine photo or a verified customer project.

Typical Applications

PC may be considered for electrical housings, covers, transparent or semi-transparent components, insert molded parts, appliance parts, and selected automotive or industrial parts. Some projects involve terminals, screws, or hardware that must be positioned before molding.

Related application pages include Insert Molding and Electronics & Electrical Components.

Molding Considerations

Review material drying, supplier processing notes, mold temperature guidance, gate design, wall thickness, and part removal. If the part has appearance requirements, the mold surface, gate location, venting, and material handling need early attention.

When inserts are involved, seating and heat transfer around the insert can affect filling, stress, and dimensional consistency.

Machine Configuration Notes

DA Series Standard Vertical Injection Molding Machines are a general starting point for vertical molding discussions. Fixed platen machines may fit straightforward parts, while table movement should be reviewed when inserts or careful removal are involved.

Final suitability depends on exact PC grade, part design, mold dimensions, insert loading method, and production target.

Related Reading

• Engineering Plastics
• Insert Molding Machine Selection Guide
• Molding Defects
• Insert Molding